Milkit - banda janta tubeless bike Rim Tape - 32mm

The strongest and most reliable tubeless rim tape on the marketSTRONG - Strongest material availableRELIABLE - Proven to be long lasting and temperature proofEASY - Good balance of strength and flex for easy installationYOUR STRONG AND RELIABLE TUBELESS RIM TAPEmilKit rim tape offers quick and easy conversion of your rim to tubeless and guarantees a reliable and long-lasting performanceAvailable in the four most popular widths – covering most rim sizesExtra strong and reliable adhesive to ensure a tight fit on your rimOptimum mix of strength and flex for easy mounting10m/11yd rolls – sufficient to set up 4-5 wheelsHOW TO USE MILKIT RIM TAPEMilKit products offer the simplest solution for tubeless installation and maintenance. We designed our rim tape to be very strong and reliable for an airtight fit, but with enough flex to make installation quick and easy.Rim tape is needed to ensure air does not escape through holes that are drilled in the rim for spokes.Choose a rim tape width that matches the inner width of your rim or is slightly larger. The rim tape should cover the whole rim base and it can even cover a part of both sides. Using too narrow rim tape can lead to air leaking between rim and tape – which can be frustrating. If it is too wide it can interfere with the tire seating correctly.For easy and effective installation:Clean rim thoroughly and ensure it is dryInstall rim tape by pulling it firmly into the rim. It must be tight and ensure there are no gaps or air trapped underneathMake sure it overlaps at least 10 cm / 4 in over the valve hole, it’s better to have a longer overlap than shorterUse two layers for high pressure wheels (above 8 bar / 120 psi)Cut rim tape at a 45° angle for the best adhesion and flexibilityInstall milKit tubeless valves into rim: pinch just a small hole into the rim tape and push valve through tape into rim